EX PROFILE Anodized

Dimensions: 100cm x 2.3cm x 3.45cm ( Lenght x Width x Height)
Model: PROFB1890

Price

25.00

Quantity
Skambinti

Description

Advantages:

small dimensions, combines two functions: glass or other material can be mounted to the profile and illuminated by LED ; ability to mount to different surfaces ( walls, floor, ceiling etc.), modern design, environment friendly
EX-ALU PROFILE assembly requirements and conditions. KLUS EX-ALU PROFILE assembly – glass: 1. Use tempered glass, 6mm thick.
2. For the hanging LED frame set stretching screws (min. 2 pieces) need to be laid out no more than 16.6cm apart and no less than 3cm apart from the ends of the horizontal glass edge (to which edge the profile is mounted).
2a. For the supporting LED frame set, stretching screws (min. 2 pieces) must be laid out no more than 16,6 cm apart and no less than 3cm from the ends of the vertical glass edge (to which profile is mounted). If the lenght of the vertical glass edge is more than 18cm, than the screw must be always inserted 8 cm below the first top screw.
3. Stretching screws must be tighten up strong enough; however not overpowering the thread and not damaging the hexagon of the screw top.
4. For the hanging LED frame set the length of the vertical glass edge can not exceed 51cm.
4a. For the supporting LED frame set the lenght of the horizontal glass edge can not exceed 51cm and the lenght of the vertical edge can not be less than the number calculated by dividing the lenght of the horizontal edge by a standard number – 1.7 (Example 1: the lenght of the horizontal edge – 51cm , divided by 1.7 equals 30cm). The calculation gives us the shortest, possible lenght of the vertical edge. Example 2: lenght of the horizontal glass edge – 21cm, divided by 1.7 equals 12.4cm. This is the lenght of the shortest, possible vertical glass edge, if the horizontal edge is 21cm.
5. For both LED frame sets (hanging and supprting) the lenght of the profile can not be shorter than the lenght of the glass edge to which the profile is mounted.
6. Assembled frame sets can be mounted by sliding the profile till it reaches stretching screws’ tops. It is very important that the length of the sliding was as long as possible. Next the profile must be blocked.
7. For the frame set mounted accordingly in nr. 6, screw tops should be set up to provide maximum possible friction while sliding the profile.
8. Type of the mounting screws may vary depnding on the surfaces to which the frame is mounted.
9. The above rules and intstructions of EX-ALU frame sets assembly must be followed. They are also available in an illustrated form on our website or on CD. We can also send the instruction in an written form via email or regular mail.
10. KLUS company also offers free consultations regarding frame sets assembly and mounting.

Staff